7 REV 42451-20120710
ENGLISH 42451
Your generator requires some assembly. This unit ships
from our factory without oil. It must be properly serviced
with fuel and oil before operation.
If you have any questions regarding the assembly of your
generator, call our help line at 1-877-338-0999. Please
have your serial number and model number available.
Remove the Generator from the Shipping Carton
1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the
generator.
3. Carefully cut each corner of the box from top to
bottom. Fold each side flat on the ground to provide a
surface area to install the wheel kit and support leg.
Add Engine Oil
1. Place the generator on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
ASSEMBLY
The recommended type of oil for use in the
generator is 10W-30. Please see “Specifications”
section for more information on oil types.
NOTE
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil. Damage to the generator as
a result of failure to follow these instructions will
void your warranty.
CAUTION
Failure to install the spark arrester may result in an
increased risk of fire.
CAUTION
Install the Spark Arrester
1. Insert the spark arrester screen into the muffler outlet.
2. Secure the spark arrester by placing the cover plate
over the end of the screen, with the lettering facing
outward.
3. Secure the cover plate with the two screws and lock
washers provided with the spark arrester kit.
Federal and local laws and administrative
requirements indicate when and where spark
arresters are required. When ordered, spark
arresters are required for operation of this generator
in National Forest lands. In California, this
generator must not be used on any forest- covered
land, brush-covered land, or grass- covered land
unless the engine is equipped with a spark arrester.
NOTE
Attaching the Engine Vibration Mounts
1. Thread the vibration mount bolt through the frame
(engine side).
2. Firmly secure the bolt to the frame with the M8 nut.
Tighten. DO NOT over tighten.
3. Repeat steps 1-2 for the remaining mount (2 total).
Attaching the Alternator Vibration Mounts
1. Thread the flange bolt (M8x20) through the vibration
mount and then through the frame (alternator side).
2. Firmly secure the bolt to the frame with the M8 nut.
Tighten. DO NOT over tighten.
3. Repeat steps 1-2 for the remaining mount (2 total).
(23 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales